|
|
|
| A variety of factors the color of the stone wall |
Lacquer, as a model of the appearance of the building materials, originated in Japan, through Taiwan incoming, and after ten years of development, lacquer on the kinds and properties of also gradually from junior to senior over. Similarly, the improvement of self clean, weatherability, use obtained, as well as with the personage inside the industry is obvious to all, Chenguang lacquer, as the earliest a group devoted to lacquer the old enterprises, in over the long haul, summed up the experience a lot, in order to solve the problem of color lacquer brand common, may study for traceability, answering questions for the customers.
As is known to all, with the continuous advancement of technology, lacquer products of better stability, however, throughout the lacquer industry, only a few enterprises dare make a commitment, to ensure no color lacquer finished. The dawn is one of them. Lacquer color, involving from the source of raw materials to the subsequent construction, this is not the single to rely on external forces can solve, need in lacquer construction process, everywhere intentions.
Is the source of trouble
Speaking of lacquer color, the color of raw materials of be the first to bear the brunt, sand is the main reason. Different regions, different ore source, even though the same color, the color difference is also very large, with the color of chrysanthemum yellow as a special case, different ore source, the color contrast is very obvious. So in the customer to lacquer manufacturers ordering, as a responsible manufacturer, dawn will often suggest customers with a number of large purchases or must stay on the basis of the plan for the amount of margin is to avoid if the waste caused by excessive lacquer need to re fill the goods, resulting in color, this is an obvious truth. Different ore source, color difference is certainly there, but even if it is in the same ore source, different batches, the color difference is inevitable, the reasons for this is because the sand is pure natural products, the formation of full by natural factors, therefore the different batches due to differences in access to raw materials place, creating a color difference.
Color difference caused by production process
If the source color control is good, is not it can be said that the color difference can be avoided? Of course not. In the process of production, production capacity of cylinder, subject to the stirring speed, stirring time constraints, the formation of lacquer wet material, due to differences in the degree of integration of the particle size of emulsion, and the sand, the corresponding color, and in order to maximize avoid chromatic aberration, expand production capacity of single cylinder become many lacquer enterprises is a major priority.
Standard construction is essential
In the construction process, the same building, should avoid using different batches of raw materials, this reason has been mentioned, at the same time, the construction, in order to better control the color difference, the same wall, should be sprayed with the same thickness, the same construction process, in order to avoid spraying uneven. In the actual construction of the light and humidity differences, and therefore in the same wall construction, should be in the corresponding period of time to complete the construction of the wall together, do not suggest a few days to complete, so as to minimize the impact of color difference.
In addition to these factors, there are many other aspects will cause a corresponding impact, such as mix different brands of paint, primer and finish color difference too big,, these in the range of human control can strive to avoid, so in the actual construction, should to cautious attitude, treat each link, effectively avoid the chromatic aberration.
Choose a comfortable bed and rest assured of the manufacturers |
|
|
